DAIMLER BUSES NORTH CAROLINA LLC Download PDF Report
Daimler Buses North Carolina LLC. submitted a model Sprinter, diesel-powered 15 seat (including the driver) 24-foot bus, for a 7yr/200,000 mile STURAA test. The odometer reading at the time of delivery was 9,737 miles. Testing started on March 26, 2008 and was completed on July 18, 2008. The Check-In section of the report provides a description of the bus and specifies its major components.
The primary part of the test program is the Structural Durability Test, which also provides the information for the Maintainability and Reliability results. The Structural Durability Test was started on April 3, 2008 and was completed on June 12, 2008.
The interior of the bus is configured with seating for 15 passengers including the driver. The test bus is not designed with free floor space; therefore the total passenger capacity is 15. At 150 lbs per person, this load results in a measured gross vehicle weight of 10,300 lbs. The first segment of the Structural Durability Test was performed with the bus loaded to a GVW of 10,300 lbs. The middle segment was performed at a seated load weight of the same 10,300 lbs due to no standees and the final segment was performed at a curb weight of 8,080 lbs. Durability driving resulted in unscheduled maintenance and failures that involved a variety of subsystems. A description of failures, and a complete and detailed listing of scheduled and unscheduled maintenance is provided in the Maintainability section of this report.
Accessibility, in general, was adequate. Components covered in Section 1.3 (repair and/or replacement of selected subsystems), with the exception of the alternator were found to be readily accessible and no restrictions were noted. Access to the alternator was hindered due to an add-on A/C compressor.
The Reliability section compiles failures that occurred during Structural Durability Testing. Breakdowns are classified according to subsystems. The data in this section are arranged so that those subsystems with more frequent problems are apparent. The problems are also listed by class as defined in Section 2. The test bus encountered no Class 1 or Class 2 failures. Of the two reported failures, one was a Class 3 and the other a Class 4.
The Safety Test, (a double-lane change, obstacle avoidance test) was safely performed in both right-hand and left-hand directions up to a maximum test speed of 45 mph. The performance of the bus is illustrated by a speed vs. time plot. Acceleration and gradeability test data are provided in Section 4, Performance. The average tim
The Shakedown Test produced a maximum final loaded deflection of 0.176 inches with a permanent set ranging between -0.002 to 0.004 inches under a distributed static load of 5,625 lbs. The Distortion Test was completed with all subsystems operating properly with the exception of the handicap device. No water leakage was observed throughout the test.
The test bus was not equipped with any type of tow eyes or tow hooks, therefore, the Static Towing Test was not performed. The Dynamic Towing Test was performed by means of a front-lift tow. The towing interface was accomplished using a hydraulic under-lift wrecker. The bus was towed without incident and no damage resulted from the test. The manufacturer does not recommend towing the bus from the rear, therefore, a rear test was not performed. The Jacking and Hoisting Tests were also performed without incident. The bus was found to be stable on the jack stands, and the minimum jacking clearance observed with a tire deflated was 6.7 inches.
A Fuel Economy Test was run on simulated central business district, arterial, and commuter courses. The results were 7.62 mpg, 9.31 mpg, and 14.72 mpg respectively; with an overall average of 9.40 mpg.
A series of Interior and Exterior Noise Tests was performed. These data are listed in Section 7.1 and 7.2 respectively.