285 W.C.

TRANSPORTATION MANUFACTURING CORPORATION (TMC) Pdf Download PDF Report

Normal

 

TMC Group Inc. submitted a model 285 W.C., gasoline-powered 22 seat (including the driver) 29-foot bus, for a 7 yr/200,000 mile STURAA test.  The odometer reading at the time of delivery was 479 miles.  Testing started on July 1, 2009 and was completed on November 10, 2009.  The Check-In section of the report provides a description of the bus and specifies its major components.

 The primary part of the test program is the Structural Durability Test, which also provides the information for the Maintainability and Reliability results.  The Structural Durability Test was started on July 22, 2009 and was completed on October 22, 2009.

 The interior of the bus is configured with seating for 22 passengers including the driver.  Free floor space will accommodate 13 standing passengers resulting in a potential load of 35 persons plus 1 wheelchair position.  At 150 lbs per person, this load results in a measured gross vehicle weight of 16,550 lbs.  In order to avoid exceeding the GAWR (9,500 lbs) of the rear axle, ballast for all 13 standing passengers and the 1 wheelchair position were eliminated.  This reduction from full capacity resulted in an adjusted measured gross vehicle weight of 14,180 lbs and was used for all dynamic testing.  The middle segment was performed at the same seated load weight of 14,180 lbs and the final segment was performed at a curb weight of 10,270 lbs.  Durability driving resulted in unscheduled maintenance and failures that involved a variety of subsystems.  A description of failures, and a complete and detailed listing of scheduled and unscheduled maintenance is provided in the Maintainability section of this report.

 Accessibility, in general, was adequate, components covered in Section 1.3 (Repair and/or Replacement of Selected Subsystems) along with all other components encountered during testing, were found to be readily accessible and no restrictions were noted.            

 The Reliability section compiles failures that occurred during Structural Durability Testing.  Breakdowns are classified according to subsystems.  The data in this section are arranged so that those subsystems with more frequent problems are apparent.  The problems are also listed by class as defined in Section 2.  The test bus encountered no Class 1, 2 or 3 failures.  Of the six reported failures all were Class 4.

 The Safety Test, (a double-lane change, obstacle avoidance test) was safely performed in both right-hand and left-hand directions up to a maximum test speed of 45 mph.  The performance of the bus is illustrated by a speed vs. time plot.  Acceleration and gradeability test data are provided in Section 4, Performance.  The average time to obtain 50 mph was 16.50 seconds.

 The Shakedown Test produced a maximum final loaded deflection of 0.657 inches with a permanent set ranging between 0.003 to 0.083 inches under a distributed static load of 14,325 lbs.  The Distortion Test was completed with all subsystems, doors and escape mechanisms operating properly.  No water leakage was observed throughout the test.  All subsystems operated properly. 

The test bus was not equipped with any type of tow eyes or tow hooks, therefore, the Static Towing Test was not performed.  The Dynamic Towing Test was performed by means of a front-lift tow.  The towing interface was accomplished using a hydraulic under-lift wrecker.  The bus was towed without incident and no damage resulted from the test.  The manufacturer does not recommend towing the bus from the rear, therefore, a rear test was not performed.  The Jacking and Hoisting Tests were also performed without incident. The bus was found to be stable on the jack stands, and the minimum jacking clearance observed with a tire deflated was 7.9 inches.

 A Fuel Economy Test was run on simulated central business district, arterial, and commuter courses.  The results were 6.26 mpg, 6.43 mpg, and 10.96 mpg respectively; with an overall average of 7.19 mpg.

 A series of Interior and Exterior Noise Tests was performed.  These data are listed in Section 7.1 and 7.2 respectively.

 

Number: 0912
Model: 285 W.C.
Manufacturer: TRANSPORTATION MANUFACTURING CORPORATION (TMC)
Vin Number: 1FDXE45589DA9725